Imation SuperDisk Installation Manual page 5

Complies with IEC 825-1 and EN60825-1 as a Class 1 LASER Product.
Class 1 Laser products are not classified as being hazardous. However, to ensure
safety consistency over the entire product life cycle, the following precautions should
be considered:
1. Use of controls or adjustment of procedures other than those specified
herein may result in hazardous radiation exposure.
2. The drive is designed to be incorporated within the Imation external
enclosure. It is not designed to be used without an enclosure.
3. Do not open the external drive housing. There are no user adjustments
nor maintenance parts inside.
United States FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receive is connected.
•
Consult the dealer or an experienced radio or television technician for help.
ii
©Imation August 1998