Mackie HDR24/96 User Manual page 5

You can do this with the HDR24/96 powered on or powered off, it
doesn't matter.
1. Plug the supplied 25' cable into the "To HDR" jack on
the back of the Remote 24.
2. Plug the other end into the "Remote" jack on the back of
the HDR24/96.
A must-have for performer-engineers: use a footswitch to punch in
and out on-the-fly, stop and start the transport, jump to the next
cue, create new cues, or select the next take. The footswitch jack
REMOTE 24
WARNING
DO NOT PLUG INTO
ETHERNET
Remote
Cable
WARNING
DO NOT NOT PLUG INTO
ETHERNET
FOOT
REMOTE MOUSE SWITCH
HDR 24/96
24TRACK 24 BIT DIGITAL AUDIO
HARD DISK RECORDER/EDITOR
120VAC
50/60 Hz 475W
TO HDR
FOOT SW
REMOTE JACK
Footswitch
WARNING WARNING
DO NOT NOT PLUG INTO
ETHERNET
FOOT
REMOTE MOUSE SWITCH
HDR 24/96
24TRACK 24 BIT DIGITAL AUDIO
HARD DISK RECORDER/EDITOR
KEYBOARD
CONCEIVED, DESIGNED, AND MANUFACTURED BY MACKIE DESIGNS INC • WOODINVILLE • WA 98072 • USA
MADE IN USA • FABRIQUE AU USA • PATENTS PENDING COPYRIGHT ©1998 THE FOLLOWING ARE TRADEMARKS OR
REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.: "MACKIE.", MACKIE DIGITAL SYSTEMS AND THE "RUNNING MAN" FIGURE.
CAUTION
WARNING: SHUT OFF POWER
RISK OF ELECTRIC SHOCK
TO UNIT BEFORE INSTALLING
DO NOT OPEN
OPT • 8 OPT • 8 OPT • 8
OR REMOVING CARDS!
REPLACE WITH THE SAME TYPE FUSE AND RATING.
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
function is assigned in the
HDR24/96 General Setup
window. This TS 1/4" jack -
and a jack on the back of
the HDR24/96 - accepts a
momentary, normally open
footswitch, available at any
reputable footswitch
emporium. For double the
fun, you can use
footswitches in the Remote
24 and HDR24/96 at the
same time.
Ethernet Jack
VIDEO ACC 1 SYNC ACC 2 ETHERNET MIDI
WARNING:
SERIAL NUMBER MANUFACTURING DATE
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
AVIS:
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
UTILISE UN FUSIBLE DE RECHANGE DE MÊME TYPE.
DEBRANCHER AVANT DE REMPLACER LE FUSIBLE