Advertisement
RoomStats etc are general representations only. However the wiring
detail can be applied to the corresponding models of most manufacturers.
Cylinder and Room Thermostat Key:
C=Common Call = Call for heat or break on rise SAT = Satisfield on rise N= Neutral
Existing Installations
1. Remove old programmer from its back plate mounting loosening any
securing screws as dictated by its design.
2. Check compatibility of existing back plate & wiring arrangement with
that of the new programmer. See online Programmer Compatibility
Guide for direction.
3. Make all necessary changes to back plate & wiring arrangement to
suit new programmer
SERVICE AND WARRANTY
Your product is not user serviceable. PLEASE DO NOT TRY TO DISMANTLE THE UNIT.
This product is guaranteed by your supplier for 5 years from the date of manufacture. If it should become defective
please contact your installer or supplier for a replacement unit or visit www.sangamo.co.uk/returns
This product must meet Waste Electronic and Electrical Equipment Regulations (WEEE) for suitable environmental
recycling, recovery and/or disposal. End of life products should be handled in line with local regulations. Alternatively
return end of life product to Sangamo for correct disposal.
CUSTOMER CARE POLICY
As part of Sangamo's continuous improvement program, the company operates a Customer Care policy. This means
we welcome your comments and complaints, as it can help us to improve our services to you, our customer.
Due to our policy of continuous product improvement and development, the specifications in this guide may be
subject to change without prior notice.
143704 Issue B
Electrical Connections
Fitting The Programmer
Loosen the two 'captive' retaining
screws on the bottom of the back
plate. Now fit the programmer
to the back plate, ensuring the
lugs of the back plate
engage with the slots
on the programmer.
Swing the bottom of
the programmer into
position ensuring the
connection pins on the
back of the unit locate
into the terminal slots
in the back plate.
Tighten the two 'captive' screws to
fix the unit securely.
Commisioning
Switch on mains supply. Referring
to the user guide:
1. Use the buttons to ensure
correct product functionality.
2. Set timing and programme
details
in
accordance
customer requirements.
3. Normally unit will be left with
channel in 'Auto' mode.
4. Leave
these
instructions with customer for
reference.
In the interests of continuous
product improvement we reserve
the
right
to
alter
specifications
and
without prior notice and cannot
accept liability for errors.
If you have a problem or require
any
further
information
contact our technical team on:
01475 745131
Sangamo Limited
Industrial Estate, Port Glasgow,
Renfrewshire, PA14 5XG
Tel 01475 745131
Fax: 01475 744567
Email: enquiries@sangamo.co.uk
Web: www.sangamo.co.uk
WEE/JH0069TY
with
installation
designs,
materials
please
Advertisement
