Mackie SA1232Z User Manual

Mackie user's manual 3-way active loudspeaker system sa1232z.
Hide thumbs
SA1232
Z
3-WAY ACTIVE
LOUDSPEAKER SYSTEM
USER'S MANUAL

   Related Manuals for Mackie SA1232Z

   Summary of Contents for Mackie SA1232Z

  • Page 1

    SA1232 3-WAY ACTIVE LOUDSPEAKER SYSTEM USER’S MANUAL...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

  • Page 3: Table Of Contents

    1.75-inch neodymium compression driver. The low frequencies are produced by two high-output 12-inch woofers. Connecting and setting up the SA1232z is a breeze. It accepts a line-level signal via a female XLR input jack. CONTENTS IMPORTANT SAFETY INSTRUCTIONS ...2 INTRODUCTION ...3...

  • Page 4: Rear Panel Description

    See “Thermal Considerations” on page 6. 8. POWER Switch Use this switch to turn the SA1232z on and off. Make sure the level control is turned down before you turn it 9. AC Receptacle This is where you connect the AC linecord to provide AC power to the SA1232z’s built-in power amplifiers.

  • Page 5: Hookup Diagram, Connections, Placement

    — so the signal coming out of the LOOP OUT jack is exactly the same as the signal going in. PLACEMENT The SA1232z speaker is designed to sit on the floor or stage. You can create a horizontal array by placing the cabi- nets side-by-side.

  • Page 6: Room Acoustics, Thermal Considerations, Ac Power

    If the thermal switch activates frequently, try turning down the level control a notch or two on the mixing con- sole (or the back of the SA1232z) to avoid overheating the amplifier. If the temperature in the room is too high, it could cause the amplifier to overheat.

  • Page 7: Service Information, Warranty Service, Troubleshooting

    AC cables, power transformers, or other EMI-induc- ing devices. • Is there a light dimmer or other SCR-based device on the same AC circuit as the SA1232z? Use an AC line filter or plug the SA1232z into a different AC circuit. •...

  • Page 8: Repair, Care And Maintenance

    If it appears that the SA1232z needs repair, you will be given a Service Request Number. Have your loudspeaker’s serial number ready. You must have a Service Request Number before you can obtain service at a factory- authorized service center.

  • Page 9: Sa1232z Specifications

    “Mackie” and the “Running Man” figure are registered trademarks of LOUD Technologies Inc. All other brand names mentioned are trademarks or registered trademarks of their respective holders, and are hereby acknowledged.

  • Page 10

    SA1232z Frequency Response On-Axis SA1232z Frequency Response On-Axis SA1232z Beamwidth vs. Frequency SA1232z Beamwidth vs. Frequency ��� ��� ��� ��� ��� �� ���������� � ���������� � �� ��� ���� �������������� SA1232z Dimensions 50.0 in/ 127.0 cm 1000 Frequency (Hz) SA1232z Directivity vs. Frequency SA1232z Directivity Index ��...

  • Page 11: Sa1232z Limited Warranty

    B. Failure to register online or return the product registration card will not void the five-year warranty. C. Service and repairs of Mackie products are to be performed only at a factory-authorized facility (see D below). Unauthorized service, repairs, or modification will void this warranty.

  • Page 12

    16220 Wood-Red Road NE • Woodinville, WA 98072 • USA US and Canada: 800.898.3211 Europe, Asia, Central and South America: 425.487.4333 Middle East and Africa: 31.20.654.4000 Fax: 425.487.4337 • www.mackie.com E-mail: sales@mackie.com...

This manual also for:

Sa1232

Comments to this Manuals

Symbols: 0
Latest comments: