Mackie SA1232 User Manual

Mackie user's manual 3-way active speaker system sa1232.
Hide thumbs
SA1232
3-WAY ACTIVE
SPEAKER SYSTEM
USER'S MANUAL

   Also See for Mackie SA1232

   Related Manuals for Mackie SA1232

   Summary of Contents for Mackie SA1232

  • Page 1

    SA1232 3-WAY ACTIVE SPEAKER SYSTEM USER’S MANUAL...

  • Page 2: Safety Instructions

    Mackie product. 11. Object and Liquid Entry — Care should be taken so that objects do not fall into and liquids are not spilled into this Mackie product. 12. Damage Requiring Service — This Mackie product should be serviced only by qualified service personnel when: A.

  • Page 3: Table Of Contents

    Graphs ...13 SA1232 LIMITED WARRANTY ...15 Don’t forget to visit our website at for more information about this and other Mackie products. Part No. 0000431 Rev. B 4/03 © 2003 Mackie Designs Inc. All Rights Reserved. According to OSHA, any exposure in ex- cess of these permissible limits could result in some hearing loss.

  • Page 4: Introduction

    SPEAKER SYSTEM THERMAL CONCEIVED AND DESIGNED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA AND MACKIE EUROPE • MANUFACTURED IN ITALY • COPYRIGHT ©2001 • THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.: moving mass, and audio "MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING...

  • Page 5: Rear Panel Description, Hookup Diagram

    THERMAL CONCEIVED AND DESIGNED BY MACKIE DESIGNS INC, WOODINVILLE, WA, USA AND MACKIE EUROPE • MANUFACTURED IN ITALY • COPYRIGHT ©2001 • THE FOLLOWING ARE TRADEMARKS OR REGISTERED TRADEMARKS OF MACKIE DESIGNS INC.: "MACKIE", AND THE "RUNNING MAN" FIGURE • PATENT PENDING...

  • Page 6: Connections, Placement

    LOOP OUT. This is also wired according to the above AES standard. The LOOP OUT connector allows you to connect more than one SA1232 to your sys- tem. Simply plug the signal source (i.e., mixer output) into the first MAIN INPUT jack, and patch that speaker’s LOOP OUT...

  • Page 7: Ac Power

    AC POWER Be sure the SA1232 is plugged into an outlet that is able to supply the correct volt- age specified for your model. If the voltage should drop below 97% of the specified line voltage, the built-in amplifiers will no longer be able to supply rated power.

  • Page 8: Thermal Considerations

    In fixed applications where 220- 230 volt service is available, we highly recommend using the SA1232 in 230 volt mode. The power supply in the SA1232 can be switched between 115 volt and 230 volt setting. Contact your local service center or Mackie Designs for information.

  • Page 9: Service Information, Warranty Service, Troubleshooting

    EMI-inducing devices. • Is there a light dimmer or other SCR- based device on the same AC circuit as the SA1232? Use an AC line filter or plug the SA1232 into a different AC circuit. • Try disconnecting the cable connected to the MAIN INPUT jack.

  • Page 10: Repair, Care And Maintenance

    Repair Service for the SA1232 is available only from one of our authorized domestic ser- vice stations or at the factory service center located in Whitinsville, Massachusetts. Ser- vice outside the United States can be obtained through local dealers or distributors.

  • Page 11: Sa1232 Specifications

    SA1232 SPECIFICATIONS Acoustic Performance –3 dB points 45 Hz-18 kHz –10 dB points 38 Hz-20 kHz Directivity Factor; Q (DI) 13.2 (11.2), averaged 2 kHz to 10 kHz System Sensitivity 103 dB, 1W@1m Max SPL long-term 130 dB Max SPL Peak...

  • Page 12: Architects And Engineers' Specifications

    “Mackie” and the “Running Man” figure are trade- marks or registered trademarks of Mackie Designs Inc. All other brand names mentioned are trade- marks or registered trademarks of their respective holders, and are hereby acknowledged.

  • Page 13: Graphs

    Graphs SA1232 Frequency Response On-Axis SA1232 Beamwidth vs. Frequency Vert BW Horz BW SA1232 Directivity Index 1000 10000 Frequency (Hz) 1000 10000 Frequency (Hz) 1000 10000 Frequency (Hz) 20000 20000 20000...

  • Page 14

    SA1232 Horizontal Off-Axis Frequency Response –10 –20 –30 SA1232 Vertical Off-Axis Frequency Response (Up) –10 –20 –30 SA1232 Vertical Off-Axis Frequency Response (Down) –10 –20 –30 1000 10000 Frequency (Hz) 1000 10000 Frequency (Hz) 1000 10000 Frequency (Hz) 0 deg...

  • Page 15: Sa1232 Limited Warranty

    Please keep your sales receipt in a safe place. A. Mackie warrants all materials, workmanship and proper operation of this SA1232 for a period of one year from the original date of purchase. If you com- plete the optional questionnaire portion of the...

  • Page 16

    ™ ® Mackie Designs Inc. Mackie Designs Inc. 16220 Wood-Red Rd. NE • Woodinville, WA 98072 • USA US & Canada: 800/898-3211 Europe, Asia, Central & South America: 425/487-4333 Middle East & Africa: 31-20-654-4000 Fax: 425/487-4337 • www.mackie.com E-mail: sales@mackie.com...

Comments to this Manuals

Symbols: 0
Latest comments: