Table of Contents
Advertisement
Function Menu
Label length
Gap length
Column printing
Measure label
Label type
Material selection
Photocell
Scan position (SP)
42
7.4 Label layout
Switch on the label printer and the display shows the main menu.
Press key
to access the function menu.
Press key
as long as you arrive the Label layout menu.
Press key
to select the menu.
Indication of label length in mm
(see chapter Technical Data, page 19).
Indication of distance between two labels in mm
(not for continuous labels).
Minimum value: 1 mm.
Press key
to arrive the next menu item.
Indication of width of one label as well as how many labels are placed
side by side (see chapter 11.1 Column Printing, page 87).
Press key
to arrive the next menu item.
Press key
to start measuring. The printer stops automatically
after termination of measuring. The determined values are displayed
and saved.
Press key
to arrive the next menu item.
Generally adhesive labels are set. Press key
labels. If the menu item Label length/Gap length contains a gap value,
this value is added to the label length..
Press key
to arrive the next menu item.
Selection of the used label and transfer ribbon material.
Press key
to arrive the next menu item.
Selection of the used photocell. The selection of one of the following
photocell types is possible:
Transmission photocell normal and inverse, reflexion photocell normal
and inverse (see chapter 11.3 Photocells, page 90).
Entry of percental label length by that the label end is searched.
Marks onto the label can be skipped.
Operating Manual
DuoPrint Series
to select continuous
10.15
Advertisement
Table of Contents
