Body Panel Replacement−Rear Body Components; Installation Diagram; Installation Guide - Toyota Supra Repair Manual

INSTALLATION
mm
5
1. Before temporarily installing the new part, apply
body sealer to the wheel arch portion.
NOTE:
1) Apply sealer approx. 5 mm (0.20 in.) from the
flange, avoiding any oozing.
2) Apply evenly, approx. 3 − 4 mm (0.12 − 0.16 in.)
in diameter.
3) For other sealing points, refer to section SU.

INSTALLATION DIAGRAM

Describes in detail installation of the new part involving repair by welding and/or cutting, but exclud-
ing painting.

INSTALLATION GUIDE

Provides additional information to more efficiently help you perform the installation.
SYMBOLS
See page IN−4.
ILLUSTRATION OF WELD POINT
Weld method and panel position symbols.
See page IN−5.
INTRODUCTION
BODY PANEL REPLACEMENT−Rear Body Components
Butt Weld
Butt Weld
Body Sealer
Body Sealer
About 5 mm
in.
0.20
Braze
2. Temporarily installing the new part and check the fit of
the front door, luggage compartment door and rear
combination lamp.
RE−27
IN-3