Carvox CX999 Operation And Installation Manual page 11

SYSTEM INSTALLATION
System Installation
1.Due to the complexity of this system, installation must only be performed by an authorized dealer.
2.Thoroughly read and become familiar with the installation instructions before beginning the installation.
3.Review system contents:
a.Main Control Unit
b.Siren
c.Communication unit with built-in Shock Sensor and Valet Switch
d.Starter Kill Relay
e.Remote Starter Module with 5-pin Starter Harness.
f.Harness:
4.Verify vehicle is equipped with electronic fuel injection, and starts/idles normally before installation.
5.Determine if vehicle is equipped with a factory theft deterrent system and obtain proper bypass module
if required.
6.Find a location to mount the hood pin switch that will not interfere with the opening of the hood, and
is not in a position that can accumulate water. The hood pin is a safety device that must be installed to
avoid remote starting during engine servicing.
7.Verify with the owner, the mounting locations for all visible components, including the LED and Receiver.
8.Verify with the owner, the optional features of vehicle security system and the features that must be
programmed during installation.
9.Inspect and perform a function test of all vehicle systems before and after the installation.
10.Always use a Volt/ohm meter for testing vehicle circuits. Never use a test light.
11.Always look before drilling any holes or mounting self-tapping screws. Be sure fuel lines and exterior
wiring looms are clear as they are often close to the chassis and difficult to see.
12.Protect all wires running from the engine compartment to the interior of the vehicle by covering with
electrical tape and split loom tubing. Be sure to use a grommet when routing wires through the firewall.
13.Properly fuse any additional accessories such as starter module, window module, door lock actuators,
etc., Making sure to power them separate from the alarm Main Unit. This will ensure the functionality of
the security system in the event of an accessory failure.
14.Remove all fuses to avoid running down the battery during installation.
15.Roll down the driver's side window to avoid locking the ignition keys in the vehicle.
FEATURES DESCRIPTION
To confirm and save the alarm time settings
with one beep confirmation and Remote Control
enters Personal Alarm mode, icon appears
on the LCD screen, the time value is the alarm
call time value. Remote Control will shift to RTC
display a little while later.
With two beeps confirmation
Note:Alarm beeping will be activated when time reaches the setting alarm
time and Remote Control will remain in the Personal Alarm mode automatically.
If you want to exit Personal Alarm mode, just press button
2sec and then press for 0.5sec till the icon
to cancel PAC Mode.
for
flashes, and press button