The Main Shaft Assembly - Cectec KINGCOBRA Service Manual

ENGINE - Assembly

THE MAIN SHAFT ASSEMBLY

N0. PART NAME
1. MAIN SHFAT
2. BEARING
3. SPACER
4. LIP SEAL
5. RETAIN C-RING
6. WASHER
7. NEEDLE BEARING (CAGE TYPE)
8. HIGH SPEED DRIVE GEAR (27T)
9. LOW SPEED DRIVE GEAR (18T)
10. NEEDLE BEARING (OPEN TYPE)
Before install gear and bearing , please lubricate with 10W/40 oil
1.Install bearing (2) into main shaft (1) , the bearing of ring side
shall be install to main shaft of gear side
2.Install spacer (3) into main shaft , then install seal (4) into
spacer (3)
3.Install a C-ring (5) into main shaft of groove , then put a
washer (6) into main shaft
4.Install needle bearing (7) and high gear (8) into main shaft ,
shall be install high gear of raised side into main shaft of gear
side
5.Install a washer (6) into main shaft then install C-ring (5) into
main shaft of outside groove
6.Install low gear (9) into main shaft then install needle bearing
(10) into main shaft , low gear of forl groove shall be in the
outside
PART NO.
46030001
46030034
46010003
40016004
RCS025
46030010
46030030
46030003
46030004
46030028
Ⅱ
- 29
Ⅱ