Sharp MX-FX11 Service Manual page 12

SW Bit
Item
No. No.
31 1 Reception CSI sending
2 Transmission Echo suppressor tone
setting No. 1
3 Transmission Echo suppressor tone
setting No. 2
4 Transmission Echo suppressor tone
setting No. 3
5 Transmission Echo suppressor tone
setting No. 4
6, 7 Reception Image capacity when
receiving
(Reflect in DIS, Do not
reflect in DTC.)
8 Not used
32 1, 2 Reception Designation of
reception size
(indicating the width of
reception capacity)
3 Transmission Training
4 Reception Reception gain
changeover when
receiving
5 Reception Time out time setting
after starting TCF
signal reception
6 Communication Time between DCS-
TCF
7, 8 Communication 300bps preamble send
time
SW selection and function
Setting to determine whether or not to send the CSI signal.
The CSI signal contains the transmission source number.
"0": Yes (send the CSI signal)
"1": No (do not send the CSI signal)
Setting to determine whether or not to have the echo suppressor tone in the
high-speed modulation mode.
"0": With V33
"1": Without V33
Setting to determine whether or not to have the echo suppressor tone in the
high-speed modulation mode.
"0": With V17
"1": Without V17
Setting to determine whether or not to have the echo suppressor tone in the
high-speed modulation mode.
"0": With V29
"1": Without V29
Setting to determine whether or not to have the echo suppressor tone in the
high-speed modulation mode.
"0": With V27
"1": Without V27
This sets the reception resolution capacity when FAX calls arrive (when
sending DIS).
Reflect in DIS, Do not reflect in DTC.
"00": Very fine
"01": Fine
"10": When small
"11": Ordinary lettering
This sets this machine's receivable document width that is notified to the other
party's machine when receiving.
"00": By loaded cassette
"01": A4 width
"10": B4 (A4, B4) width
"11": A3 (A4, B4, A3) width
When using the loaded cassette, width is as follows depending on the
maximum cassette size.
A5/5.5x8.5R size: A4 width
B5 size: B4 width
A4/8.5x11 size: A3 width
8.5x13/8.5x14: A3 width
B4 size: B4 width
11x17: B4/A3 width (changeover by means of the FAX soft SW)
A3 size: A3 width
A3 width is adopted in cases where a tray capable of receiving and printing
facsimiles is not set and cases where all cassettes are open.
Setting whether the training in high speed sending is set to long or short in
V.17.
"0": Short
"1": Long
Setting to determine the FTT determination method when confirming TCF
reception.
"0": Judge the EQM value to determine if the received data is 0
"1": Only judge from the EQM value. Accordingly, TCF confirmation becomes
loose
The time for time out is set after starting TCF signal reception.
"0": 4 seconds
"1": 2 seconds
Setting to determine how many seconds in the interval between DCS
transmission and sending of the TCF signal.
"0": 75msec
"1": 150msec
75±20ms in the ITU-T standard.
The preamble send time is set in the FSK signal sending.
"00": 0.5 seconds
"01": 1 second
"10": 1.5 seconds
"11": 2 seconds
MX-FX11 FAX SOFTWARE SWITCH 2 – 8
System settings
Setting
Setting
Communication/
Setting
Setting
Communication/
Setting
Setting
Setting
Communication/
Setting
Setting
Adjustment value