Delixi LGK-ID IGBT User Manual page 8

1) Apply sealant on the copper gas nozzle and set to position of IN and OUT.
2) Apply sealant on heading and then set it to the top.
3) Fix the joint frame in position by nut.
4) Unscrew nut and fix gas valve on joint frame. Adjust air pressure by pressure valve ("+" up, "-" down).
5) Press relief valve and air pressure of 4 kg will be displayed on heading.
6) Turn on discharging knob and turn it off after water is discharged completely if water in container is
excessive.
4.4 Assembly instruction for cutting torch
1) Insert one end of electrode to cutting torch.
2) The other end of electrode connects with aviation socket.
3) One end of nozzle connects with electrode and the other end connects with protective casing.
4) Assemble into cutting torch and then screw it.
IV. Installation and Operation
Figure 3
- 6 -