Delixi LGK-ID IGBT User Manual page 7

IV. Installation and Operation
4.2 Connection for output cable (Figure 1)
2a Connection for cutting torch
Connect copper nut of cutting torch with conductive cable. And connect plug on cable clamp to terminals on front
panel by screwing in clockwise (prevent air leakage).
2b Connection for switch on cutting torch
Connect plug of switch on cutting torch to switch and screwing the electrode in sequence, and then assemble
nozzle.
2c Grounding cable
Connect one end of grounding cable to the plug under front panel with mark of plug and rotate in clockwise; the
other end of grounding cable connects to work piece.
4.3 Installation and operation of air compressor (Figure 2 and Figure 3)
Figure 2
- 5 -