Table of Contents
Advertisement
1
Notes:
The included screws and anchors are used to
l
install the camera to a solid surface. (e.g. concrete)
If installing on loose or thin material surfaces , use the
appropriate anchors (not included) with the screws.
Install the camera securely.
l
Use Category (Cat) 5e or higher cable.
l
Mounting the camera to a solid surface
(1) Attach the supplied Alignment Sticker to the surface.
(2) Drill four pilot holes (Ø3/16inch x 1.57inch(D))
(4.8mm x 40mm(D)) through the four circles on the sticker.
(3) Hammer the supplied plastic anchors into the holes.
(4) Drill a cable hole (Ø0.8inch(Ø20mm)) at the cabling cutout on the sticker, and lead the cables
through this hole.
(5) Align the four mounting holes of the Camera with the four plastic anchors; insert the included
four screws to the corresponding holes and tighten them with a driver.
Cable installation
If possible, lead all cables behind the camera body through a wall or ceiling.
If this is not possible, detach the slide cover from the dome cover to route the
cables through the side.
16
16
16
2
3
NOTE
You may also install the camera to a U.S. standard 4 in. junction
box. You can align the camera's curved slots with the mounting
holes on a junction box. Use diagonal mounting positions on the
camera to match those on a junction box. And secure the camera
with supplied screws.
5
Advertisement
Table of Contents
