Appendix C - Power Injector Duo Specifications; Appendix D - Remote Reset - Bad Boy Xtreme N Installation And Operation Manual

Bitstorm Inc.

Appendix C - Power Injector DUO Specifications

Injector Power Input:
Injector Power Output:
Output Short Circuit Protected:
Power Reverse Polarity Protection:
Thermal Shutdown:
Port 2 Power Injecting (PoE):

Appendix D - Remote Reset

A reset causes settings to be restored to a known state. For example, this can
be useful to restore username or password to default values. To perform a
Reset operation, do the following (read all instructions first):
1) The DUO will send a signal to perform a remote reset to all connected
devices. Unplug the cables of any device that you do NOT want to have
reset. Leave connected the device(s) that you wish to have reset.
2) Power on and ensure devices have had enough time to fully start.
3) Using a small screw driver or other flat ended, non sharp object, insert it
into the slot until you feel and hear a click. Note: Do not use force!
4) Hold the reset button depressed for at least 30 seconds and then release.
If the button becomes unpressed during this time, cycle the system off and
on, and wait 30 seconds before trying again. Disregard any LED patterns
displayed on connected devices.
5) Power off. Tip: You can simp-
ly remove the barrel power
plug from DUO. Verify that
the Port's green power LED
turns off.
6) Reconnect power and wait
sufficient time for the devices
to fully restart. Your Xtreme
should now be restored to
original default settings.
12
M-POE-DUO-S15.5
Output Ripple:
Efficiency:
Port PoE Pins:
Startup Delay:
AC Adapter:
DC Power Cable:
Dimensions:
Remote Reset:
www.bitstorm.com
Bad Boy Xtreme N & MJ
5-30 Vdc
15.5 Vdc, 1A max
< 80 mV
Yes – protection circuit limited to 5A max
Yes – yellow LED indication
Yes
up to 90%
Yes – enabled / disabled by jumpers
Positive(+) 4 & 5, Negative(-) 7 & 8
approx. 2 to 4 seconds
Included, 100-240 Vac, North American
Included
3.6" x 2.6" x 1.1" (9.2cm x 6.6cm x 2.8cm)
Yes - Button on side