Dynacraft Surge Owner's Manual
  1. Manuals
  2. Brands
  3. Dynacraft Manuals
  4. Scooter
  5. Surge
  6. Owner's manual

Dynacraft Surge Owner's Manual

Off-road electric scooter
Hide thumbs
Table of Contents

Advertisement

Quick Links

OWNER'S MANUAL
OFF-ROAD ELECTRIC SCOOTER
,
this manual contains important safety
performance and
.
maintenance information
read the manual before taking your
-
first ride or allowing your child to ride your new off
road
.
.
electric scooter
keep the manual handy for future reference
DO NOT RETURN TO STORE!
QUESTIONS OR COMMENTS?
STOP
1-800-288-1560
FOR AGES FOURTEEN AND UP
MAXIMUM WEIGHT: 220 lbs (100 kg)
NOTE: Illustrations in this Manual are for reference purposes only and may not reflect the exact
appearance of the actual product. Specifications are subject to change without notice.
WARNING
This off-road electric scooter is not meant to be used on rough
terrain and should only be ridden on relatively smooth, flat surfaces. Please read and
follow the indications in this manual.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Surge and is the answer not in the manual?

Questions and answers

Related Manuals for Dynacraft Surge

Summary of Contents for Dynacraft Surge

  • Page 1 OWNER’S MANUAL OFF-ROAD ELECTRIC SCOOTER this manual contains important safety performance and maintenance information read the manual before taking your first ride or allowing your child to ride your new off road electric scooter keep the manual handy for future reference DO NOT RETURN TO STORE! QUESTIONS OR COMMENTS? STOP...

  • Page 2: Table Of Contents

    TABLE OF CONTENTS Introduction, Safety and Warnings Before You Begin Assembly Off-Road Electric Scooter Parts Assembly Before You Ride Detailed Maintenance and Repair Troubleshooting Guide Warranty THIS VEHICLE MUST BE ASSEMBLED BY AN ADULT. PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATION.

  • Page 3: Introduction, Safety And Warnings

    INTRODUCTION, SAFETY, AND WARNINGS ABOUT THIS MANUAL: This manual was written to help you get the most performance, comfort, enjoyment and safety when riding your new off-road electric scooter. It is important for you to understand your new off-road electric scooter. By reading this manual before you or your child go out on your first ride, you will know how to get the most from your new off-road electric scooter.
  • Page 4 Always wear appropriate clothing and shoes, including long sleeved shirts and long pants and lace-up or similar shoes with rubber soles. Never ride barefoot or in sandals and make sure that shoelaces or other fasteners are tied and kept away from the wheels and drive system of the off-road electric scooter.
  • Page 5 • Children must be supervised by an adult to be safe. • Always be alert and ride your off-road electric scooter defensively. Watch out for obstacles that could catch one of the off-road electric scooter’s wheels or force you to turn suddenly and/or lose control. Be careful to avoid pedestrians, persons using other wheeled products (including roller or in-line skates, skateboards, scooters, bikes, etc.), children or animals who may enter your path.
  • Page 6 • Do not to allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts, wheels, or drivetrain, while the engine is running. • Before each cycle of operation, the operator shall perform the preoperation checks specified in this manual and/or by the manufacturer, including: .

  • Page 7: Before You Begin Assembly

    USING THE CHARGER The charger should be examined regularly for damage to the cord, plug, enclosure and other parts. In the event such damage has occurred, the off-road electric scooter should not be charged until the charger has been repaired by qualified personnel or replaced. Use only the supplied, recommended charger.

  • Page 8: Off-Road Electric Scooter Parts

    OFF-ROAD ELECTRIC SCOOTER PARTS Part Description Part Description Handlebar Grip (Right / Left) Battery (3x12V/7AH) Variable Speed Twist Reset Button Handlebar Clamp Control Module Handlebar Charger Port Brake Lever Assembly Stem Handlebar Steerer Tube Scooter Body / Frame Clamp Rear Fender Head Set (Upper / Lower) Chain Guard Front Fork...

  • Page 9: Assembly

    ASSEMBLY Scooter Body and Front Fork Assembly Tools Required: 13mm wrench & 17mm wrench (not included) 1 Insert the stem (assembled with the front fork, front wheel and the steerer tube already) into the scooter body as shown. Note: Make sure the cable wires are smooth and out of the way before inserting (to avoid kinks or breakage) 2 Align the holes A &...

  • Page 10: Handlebar Assembly

    Handlebar Assembly Tools Required: 5mm Allen Key (included). Attach the handlebar onto the handlebar steerer tube as shown, and tighten the handle- bar in the handlebar clamp (tighten the four bolts with the included 5mm Allen Key). Note: Make sure that cable wires are smooth and out of the way before attaching the handlebar.

  • Page 11: Charging The Battery

    Charging the Battery Your off-road electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to use. Initial charge time: 18 hours, and never charge the battery longer than 30 hours. Recharge time: up to 12 hours, and never charge the battery longer than 30 hours.

  • Page 12: Before You Ride

    charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger. Chargers have built-in overcharge protection to prevent the battery from being over-charged. Charger will get warm during use. This is normal for some chargers and is no cause for concern. If your charger does not get warm during use, it does not mean that it is not working properly.

  • Page 13: Detailed Maintenance And Repair

    Battery: Always make sure the power switch is in the “off” position whenever the off-road electric scooter is not in use. Never store the product in outdoor conditions, never store it in the rain, and never store the product in freezing or below freezing temperatures.
  • Page 14 Front Wheel Replacement Tools required: 12mm wrench & 17mm wrench (not included) 1. Using a 12mm wrench and a 17mm wrench, loosen the front wheel axle and cap nut the same time as shown. 2. Draw the front wheel axle out to replace the front wheel. Note: Front Wheel Hardware Sequence: A.
  • Page 15 Chain, Rear Brake and Rear Wheel Replacement Tools required: Phillips screwdriver, 8mm wrench, 10mm wrench, 12mm wrench and 17mm wrench (not included). 1. With a Phillips screwdriver, loosen the four screws in the chain guard and remove the chain guard. 2.
  • Page 16 Remove rear wheel for replacement (or replace with new rear brake or new chain at this time). Note: Rear wheel hardware sequence A. Cap Nut E. Rear Wheel Axle B. 6 Type Spacer F. Rear Wheel C. Rear Brake G. Long Spacer D.
  • Page 17 11. Tighten the 4 screws on the chain guard with a Phillips screwdriver. Adjust Chain Tightness 1. Use a Philips Screwdriver to loosen the brake housing anchor (do not remove) 2. Use a 12mm and a 17mm wrench to loosen the rear wheel axle on the left and right sides at the same time, and then slightly move the rear axle...
  • Page 18 Battery Care and Disposal Do not store the battery in temperatures above 75°F (23.5°C) or below 32°F(0°C). THIS OFF-ROAD ELECTRIC SCOOTER CONTAINS SEALED LEAD ACID BATTERIES WHICH MUST BE RECYCLED IN ACCORDANCE TO YOUR LOCAL AND STATE LAWS. PLEASE CAREFULLY READ AND UNDERSTAND THE FOLLOWING DISPOSAL INSTRUCTIONS: Disposal: This product contains sealed lead acid batteries which must be disposed or recycled in an environmentally safe manner.

  • Page 19: Replacement Parts

    Charger The charger supplied with the off-road electric scooter should be regularly examined for damage to the cord, plug, enclosure and other parts. And in the event of such damage, the off-road electric scooter must not be charged until the charger has been repaired or replaced.

  • Page 20: Troubleshooting Guide

    The average rechargeable battery life is 1 to 2 years depending on off-road electric scooter conditions and use. Replace only with Dynacraft recommended replacement batteries. Brakes are not adjusted correctly Refer to the instructions on adjusting (brake too tight ) the brakes on page 12.
  • Page 21 Make sure they times it does are tight. Motor or electrical switch damage Contact Dynacraft Customer Service at 1-800-288-1560 Off-road electric scooter makes Chain is too dry Apply a lubricant such as 3 in 1 ™...

  • Page 22: Warranty

    Parents that allow their children to ride taking such actions will assume their own risk and the risk of injury to their children, and Dynacraft will not be responsible. THE PURCHASE OF THIS OFF-ROAD ELECTRIC SCOOTER WILL CONFIRM THE BUYER’S AGREEMENT THAT DYNACRAFT’S LIABILITY UNDER THIS WARRANTY...
  • Page 23 SB 1918/Cal. Veh. Code, §§ 406, 407.5 (CALIFORNIA) DISCLOSURE YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ ELECTRIC VEHICLE. TO DETERMINE IF ANY COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR INSURANCE AGENT...
  • Page 24 Cal. Veh. Code, § 407.5 (CALIFORNIA) DISCLOSURE (IF APPLICABLE) YOU MAY NOT MODIFY OR ALTER THE EXHAUST SYSTEM OF THIS OFF-ROAD ELECTRIC SCOOTER TO CAUSE IT TO AMPLIFY OR CREATE EXCESSIVE NOISE PER VEHICLE CODE SECTION 21226, OR TO FAIL TO MEET APPLICABLE EMISSION REQUIREMENTS PER VEHICLE CODE 27156.

  • Page 28: Customer Service

    Having this information is required and helps us handle your call more effectively. DO NOT return this item to the store. STOP Please call Dynacraft for assistance. Dynacraft BSC, Inc. 2014 Printed in China 89 S. Kelly Rd., American Canyon, CA 94503 Call Toll Free 1.800.288-1560...

Table of Contents