Configuration Options List - Just Add Power Cardware 2G HD over IP Dealer Support Manual

2G HD over IP Dealer Support Manual – Page 10

Configuration Options List:

Configuration options are settings saved in flash memory. These settings are used by the 2G firmware. The 2G
firmware reserves two flash partitions for this purpose. One is read only (RO), the other one is a read-writable
(RW) partition. The Just Add Power factory default settings are saved in the RO partition. Changes are saved in
the RW partition. When the same configuration name is defined in both partitions, the setting in RW partition will
be used (unless especially noted otherwise).
 s0_baudrate
 DESCRIPTION: The static baud rate used under RS232 over IP Binary mode. For example: "115200-
8n1" means using "115200" baud rate with data bits "8", parity "None" and stop bits "1".
 DEFAULT: 115200-8n1
 PARTITION: RO, RW
 no_soip {y/n}
 DESCRIPTION: Used to turn ON/OFF the external RS232 UART1 serial over IP port.
 DEFAULT: n (the port is enabled as Type 1 ASCII RS232 in the factory)
 soip_type2 {y/n}
 DESCRIPTION: Used to change the external RS232 UART1 serial port mode where type 1 is ASCII and
type 2 is BINARY
 DEFAULT: n (the port is enabled as Type 1 ASCII RS232 in the factory)
 soip_type2_token_timeout
 DESCRIPTION: Used to set the idle activity timeout disconnect function for Type 2 RS232
 DEFAULT: 3 seconds

This variable can be set to whole numbers 1 or higher representing whole second increments

$./astparam r
©2011 Just Add Power Cardware Co, Inc. All rights reserved. Unauthorized use or disclosure prohibited. V1.2
soip_type2_token_timeout 1