Advertisement
Quick Links
Dishwasher Service Manual
Type:
DW5A/DW5B/DW5E/DW5F/DW5H/DW5AL/DW
5HL
Commonly Used Tools
For the sake of safe and efficient manipulation, you should prepare and learn to use the
following tools prior to servicing the dishwater:
Cross screwdriver,
Common screwdriver,
Torque spanner,
OTK caliper and universal meter.
Attention:
never measure the resistance of live cord. Otherwise, you measuring device
The trouble shooting
Problems
E1
The water supply is turned off
Inlet hose is bended
The water pressure is too low
may be damaged.
Reasons
Directions
Turn the water supply on
Put the hose in the right way
Minimum water pressure of
0.03Mpa
Advertisement
Related Manuals for Jocel DW5A
Summary of Contents for Jocel DW5A
- Page 1 Dishwasher Service Manual Type: DW5A/DW5B/DW5E/DW5F/DW5H/DW5AL/DW Commonly Used Tools For the sake of safe and efficient manipulation, you should prepare and learn to use the following tools prior to servicing the dishwater: Cross screwdriver, Common screwdriver, Torque spanner, OTK caliper and universal meter.
- Page 2 Water valve is damaged Replace the water valve Water valve or hose is blocked Disassemble and clean the water valve or hose Damaged or defective drain pump Replace the drain pump Put the hose in the right way Drain hose is obstructed or bended Working switch wring is wrong connected Repair the wiring The floater base Is too dirty ang cause...
- Page 3 element break Defective electric control Replace electric control Drain hose loop is too low. Move drain hose to proper height. Water siphons Drain hose connected to a floor drain not Install a vent air gap at counter top. properly vented. Noisy pump Debris in bottom of tub sump area Clean out the sump area...
- Page 4 The dishes shall face the water flow from the spray arm for free washing. Do not place the dishes in an overlapped way. Load heavy pans and large soup bowls downwards. If the upper racks are barred from water flows, do not place articles on them any more. Leave some space in the front of the wire basket so that the water flow may wash out the dishwater detergent from the detergent trough in the inner door.
- Page 5 This dishwasher is completely sealed. In order to repair internal parts, you have to remove the outer casing before you can check and repair the parts. An ohmmeter and the ability to read circuit diagrams are needed in this step. Removal and replacement: Turn all the switches OFF and pull out the power cord plug.
- Page 6 In case of worn out slider, micro switch failure or deformed micro switch spring, troubles may occur and the dishwasher will stop to work as usual. Removal and replacement: Pull out the power cord plug prior to servicing the door lock mechanism. Remove the outer casing.
- Page 7 If switch trouble is suspected, check whether the dishwasher is level. If it is in level position, remove the outer casing.Add water to the inner container, and check whether the float and lever is choked.In case of choking, correct it.If the dishwasher does not work when the water level is over 92mm, the switch might be obstructed or the motor wring is wrong connected .
- Page 8 d. Checkthe capacitor, if necessary, replace a new one. e. Check the circulation pump for defects. In case of defective pump, replace it in the following manner: (1) Remove the inlet hose clamp and the circulation pump; (2) Replace a new circulation pump; (3)Put on a new inlet hose clamp and connect the tubes and wires;...
- Page 9 b. Remove the connecting screws around the bottom pan and the screws to thecirculation motor support, the drain motor and the pressure switch bracing bar. c. Check the capacitor and, if necessary, replace a new one. d. Check the circulation pump for defects. In case of defective pump, replace it inthe following manner: (1) Remove the inlet hose clamp and the circulation pump;...
- Page 10 to prevent water leakage at the thermostat end. Replace the connecting wires, bottom pan and outer casing. The dispenser releases automatically the brightness liquid into the machine at the final rinsing stage. The brightness liquid reduces the surface tension of the water and eliminates dirty spots from the dish surface. The dispenser can hold brightness liquid for one month use.