Advertisement
1.
Remove the plastic cover on the end of the handlebar stem by first removing the Velcro cover on top of the
handlebar stem and then loosening the chrome 13 mm bolt by 2-3 Turns to the left. The plastic cover should
slide off.
2. Once the bolt is loose and the cover has been removed, insert the handlebars. Twist the handlebars so that it
is perpendicular to the frame.
3. Tighten 13 mm bolt with provided wrench on top of stem until front wheel and handlebars won't twist.
Installing and Adjusting Seat
The proper seat height is achieved when your child can put both feet on the ground at the same time when
seated. If the seat is too high or too low, use the quick-release to loosen the seat clamp bolt, adjust the seat to the
proper height, and retighten quick release. There is a line on the seat tube describing its highest setting. Do not
exceed this limit, it is dangerous and can permanently damage your bike.
Insert seat post into seat tube opening and align your seat with the frame. Once the seat is positioned to the
proper height and direction, tighten the silver quick-release until the seat won't rotate or slide up and down.
Advertisement
