Dmx Mode - ADJ FOG FURY JETT User Instructions

Hide thumbs Also See for FOG FURY JETT:
Table of Contents

Advertisement

Fog Fury Jett

DMX Mode:

Operating through a DMX controller gives the user the freedom to
create their own programs tailored to their own individual needs. DMX
control for the Fog Fury Jett can be used to just control light output
with no fog output, or it can be used to control both. The Fog Fury
Jett has 5 DMX channel modes; 1, 2, 3, 5, & 7 channels. See pages
12-13 for the DMX channels and traits.
1. This function will allow you to control each individual fixture's
traits with a standard DMX 512 controller.
2. Press the either the MENU button until "dX" is displayed. "X" rep-
resents the current DMX channel mode that is displayed. There
are 5 DMX channel modes.
3. When you find your desired DMX channel mode press the ENTER
button. "A.XXX" will be displayed. "XXX" represents the current
displayed DMX address. Use the UP or DOWN buttons to find
your desired DMX address.
4. Please see pages 12-13 for DMX channel modes, values and
traits.
5. After you have set your DMX address plug in the fixture via the
XLR connections to any standard DMX controller.
ADJ Products, LLC - www.adj.com - Fog Fury Jett Instruction Manual Page 10
DMX Mode
Fog Fury Jett
Always be sure to maintain an adequate supply of American DJ
Brand Fog Juice in the fluid reservoir. Running the fog machine
dry will cause pump failure and or clogging. This is the largest
cause of failure in fog and haze machines. Only American DJ Fog
Juice is recommended and not all fog juice is created equal.
Wirelesss Remote Operation:
receiver to the fog machine. Set the machine to your desired wireless
remote channel setting. See page 9. Once the machine is plugged
in and turned on, a red power LED on the receiver will glow indicat-
ing the unit is receiving power. The unit has a warm up time of about
nine (9) minutes. After the unit has warmed up, a GREEN LED on
the receiver will light indicating the unit is ready to emit fog. To emit
fog, simply press the corresponding number button on the remote
for desired length of time. If the GREEN LED is on and fog does not
come out after holding the button down for 30 seconds, check the
fluid tank and make sure you have enough fog juice.
Caution:
disconnect the power supply.
ADJ Products, LLC - www.adj.com - Fog Fury Jett Instruction Manual Page 11
Wireless Remote Operation
Start by connecting the remote
Before removing or replacing the remote control unit

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents