Canon CanoScan 9000F Quick Start Manual page 15

Scanning Film
35 mm Slides
Align the Film Guide's tab with the FILM symbol on
the platen glass of the scanner.
Place a slide or slides face down (correctly viewed
from below) in the Film Guide as shown in the
figure on the right.
120 Format Films
Align the Film Guide's tab with the FILM symbol on
the platen glass of the scanner, then open the Film
Holder and remove the Film Retainer Sheet.
Place the film face down.
Close the Film Holder.
• Leave a gap of 5 mm or greater between
films when placing two or more 120 format
films on the platen glass.
• Ensure that there is no gap between the
edge of the film and the Film Guide on the
side near the Calibration Slot.
14
Calibration Slot
Calibration Slot