Windows will identify Xponent and will ask if you want to search the
Internet for a driver. Select "No, not this time" and press "Next"
8. Windows will display a "Found New Hardware" Wizard.
9. Choose "Install software automatically" and click "Next."
10. Once the Wizard has completed, click "Finish."
11. Once the installation is complete, you will see a message pop up stating,
"Your new hardware is installed and ready to use."
Windows may repeat sections 7 through 10 of the installation
process. This behavior is normal.
IMPORTANT: Be careful not to touch Xponent's controls when the unit is
powering on. Xponent automatically calibrates itself when powering up and
touching any of its controls during startup may cause the controller to work
in unexpected ways. The Progress Meters on each deck indicate the status
of the calibration; once all of the Progress Meter LEDs are illuminated, the
remaining buttons on the unit will become lit and Xponent is ready to use.
Torq Xponent Quick Start Guide