Finishing the Zone Keypads
Figure 10—Zone Keypad Wiring
Figure 10 shows the wiring hookups for the backside connectors of the Zone Keypad (XDM46K).
How to read the schematic:
1.
The 16-gauge (power) and 18-gauge (for the speakers), 2-conductor wires attach to the 1x6
connector. The wire that provides power from the controller attaches where indicated by the
label on the connector – the solid red indicates the position of the positive wire while the
striped red indicates the position of the negative wire. The position of the speaker +/- L and +/-
R is indicated by the L+, L-, R+ and R- lettering on the label.
2.
The 1x10 connector attaches to the two CAT-5 cables. On the label, a heavy black line separates
the connection of the two wires. Any unused wires are cut off. Refer to the connector label for
the proper position of each color-coded wire. From top to bottom, the color code is as follows:
blue/white, blue, green, orange, brown, and brown/white. This group is for the CAT-5 cable that
goes to the wall plate. The remaining color codes are orange, orange/white, green, and
green/white. This group is for the CAT-5 cable that carries the controller communication data.
How to Make the Connections
•
Carefully strip insulation on wires from 3/16 to ¼ inch. Do not strip more than ¼ inch of insulation
off of wire. Strip approximately 1/4 inch of insulation from each wire conductor.
•
Attach all wires to their specific location as labeled on the connectors and as shown in the wiring
connection detail.
M&S Systems | 800.421-1587 | www.mssystems.com
XDM
4600
17