Features - OTS MK-7 BUDDY-LINE User Manual

Additionally, the divers should be dressed out to allow a quick disconnect from
the ComRope to allow for a situation where a diver must free himself from the
ComRope.
In the event divers and the surface tender lose voice communications, both should
have in place a back-up rope-pull system for communication. See Table 1 (p. 9)
for the line-pull system recommended by OTS.
3.2

FEATURES

See Figures 1 and 2 for an exploded view of the MK-7 Buddy Line system.
Note: The ComRope can be set up for many types of diving masks and/or
earphone-microphone assemblies. If you are not sure what to order, consult
an OTS dealer or OTS directly for the configuration you require.
1. Headset with boom microphone
2. Noise-canceling boom microphone
3. Female Amp connector
4. Record-out plug (male mini, line level)
5. Small o-ring
6. Male Amp connector
7. Gripper ring
8. Female Amp connector (for ComRope)
FIGURE 1: MK-7 Buddy-Line
9. Upper electronics module
10. Tender volume control
11. Diver 1 and Diver 2 volume controls
12. Housing's large o-ring
13. Battery pack contacts (copper plating)
14. Eight-cell battery pack (SCB-1)
15. Stainless steel latch
16. Lower housing (battery compartment)
4