Batteries - OTS MK-7 BUDDY-LINE User Manual

An SCB-1 eight-cell AA battery pack (Fig. 1, #14, on p. 4) is provided with the MK-7
Buddy-Line and is located in the lower housing (Fig. 1, #16). The SCB-1 battery
pack consists of an assembled SP-8 battery holder, foam spacer, and contact PCB.
Install eight AA alkaline batteries into the SCB-1 battery pack as follows:
1. Locate the latches on the sides of the lower housing (Fig. 1, #15). Pull up on
the latches simultaneously.
2. Separate the upper and lower modules while being careful not to damage the
o-ring or battery pack contacts (Fig. 1, #12 & 13).
3. Remove the SCB-1 eight-cell battery pack (Fig. 1, #14) and install eight fresh,
1.5-volt alkaline AA batteries per the diagram on the SCB-1.
4. Verify that the o-ring (Fig. 1, #12) is in place, lightly lubricated with a high-
grade silicone grease, and free of debris.
5. Align the SCB-1 contacts to the right when looking through front of lower
housing. Insert the SCB-1 battery pack into the lower housing. Carefully mate
the upper and lower housings together. Ensure that nothing is on the o-ring or
mating surface.
6. Connect the latches from the lower housing to the upper strikes. Pull down
the latches simultaneously until fully down. This will spring-load the upper
and lower assemblies.
7. Look all around the MK-7 to verify the upper and lower assemblies appear
evenly attached with no high spots.
SECTION 5

BATTERIES

10