Rear Panel - Lyngdorf Audio CD-1 Owner's Manual

Rear panel

Fig 2: CD-1 rear panel.
(1 & 2) Analog output right and left
RCA Connectors
(3 & 4) Analog balanced output right and left
XLR Connectors for balanced output
(5) Optical output
Toslink Connector for digital output
(6) AES Output
XLR Connector for AES output
(7) SPDIF
SPDIF output
(8) RS232 INPUT/AUX
AUX and INPUT RJ45 connectors
The RS232 communication connectors are for communication to a PC or remote control
from Lyngdorf equipment with broadcast commands or linked control between other
components. The Input is looped to Aux for daisy chaining of components. The "INPUT" is
used for connection to a PC/computer to upgrade the firmware.
(9) MAINS INPUT
IEC320 type connector
(10) POWER MODE SELECTION SWITCH
The CD-1 has a large switch above the MAINS INPUT (9) selected to the correct voltage
for your location or Country's power supply. This switch is selected to either 115V or 230V
operation.
WARNING: Always check the correct voltage 115V or 230V operation has
been selected for the voltage in your location or country. Failure to do this
may result in serious damage to your CD-1 component.
- 10 -