TABLE OF CONTENTS ACCESSORIES ............................3 REMOTE CONTROL ..........................4 FRONT PANEL ...........................5 REAR PANEL ............................6 MENU SYSTEM ..........................7 NOTES OF IMPORTANCE .........................9 CONNECTORS ..........................10 TECHNICAL SPECIFICATIONS ......................11...
ACCESSORIES 1. You should find the following accessories included: digital info analog menu TUNER channel volume ENTER random repeat Mains cord Remote control...
REMOTE CONTROL To control the CD player the CD key should be pressed. 1. On / Standby 2. Numerical buttons 0-9 Direct selection and input of tracks on CD. 3. Info Toggles between showing additional CD information (e.g. album name, song name, and artist), if available. When turned On, track information will be reduced in height.
FRONT PANEL 1. Play / Select • Push to Play and Pause. In the menu mode pushing is used as the select-function. • Holding down the button will access the main menu. • Turn the wheel to skip left and right between tracks or menu items. 2.
REAR PANEL CD-2 Designed and manufactured in Denmark by SL Audio A/S www.lyngdorf.com Audio Equipment 3YZ9 CLASS 1 Warning. To reduce the risk of fire LASER PRODUCT or electric shock, do not expose this apparatus to rain or moisture Avertissement: Pour réduire le THIS PRODUCT COMPLIES WITH FDA RULES 21 CFR risque d'incendie et de décharge...
Display Timeout The timeout can be set to On or Off. On is a 10 second display timeout. Auto Off Auto off will automatically turn off the CD-2 after it being idle for 5 minutes. Advanced • Software info Displays the firmware version.
Page 8
1. Download the new firmware from www.Lyngdorf.com 2. Upload it to the root of a FAT32 formatted USB stick. 3. Go to Software Update in the Advanced menu of the CD-2 and click Yes. 4. The display should show “Updating: Name of firmware file”.
Operating Voltage Check the label on the CD-2 rear panel and verify you have the version with the proper voltage for your area. Connect the power input only to the AC source printed on the label. The warranty will not cover any damage caused by connecting to the wrong type of AC mains.
CONNECTORS Mains Connector Mains voltage to the CD-2 is applied via an IEC320 type connector. The supplied cable with safety ground should be used to connect the CD-2 to a mains outlet. Connect the power input only to the AC source printed on the label and the setting shown on the voltage selector switch.
TECHNICAL SPECIFICATIONS All audio measurements, except frequency response, are measured with a 20KHz low-pass filter in accordance with AES-17. Measured on Unbalanced outputs - RCA (phono). Analog audio outputs Parameter Value Note Frequency response L/R +/- 0.02 dB 20 – 20000 Hz Signal-to-noise ratio 114 dBA (‘infinity zero’...
Page 12
44.1 kHz. Technical Assistance If you have any problems with or questions regarding your Lyngdorf Audio product, please contact your nearest Lyngdorf Audio representative or go to www.lyngdorf.com...