Parts And Functions; Operation - Azden i-Coustics PRO-XD Operation Manual

PRO-XDT Transmitter

Parts And Functions

Antenna
Power & Sync Button
Input Selector
Aux Input
Belt Clip
Reset
Power Indicator
Signal Indicator
Microphone Input
Mini USB Charging Port

Operation

Power On/Off
Turn on the PRO-XDT by pressing and holding the Power Button
battery power the Power Indicator light
life is low. To turn off the transmitter, press and hold the Power Button
Indicator light goes off.
Signal Indicator
The Signal Indicator
unit is broadcasting a wireless signal. If this light is flashing green, it indicates that the transmitter is in sync
mode and trying to establish a connection. See detailed instructions on pairing on page 4.
Input Selector
Select the audio input source with the Input Selector
towards the microphone icon selects the Microphone Input
"AUX IN" selects the Aux Input
simultaneously (Fig. 3).
Fig. 1
Microphone & Aux Inputs
The PRO-XDT has two audio inputs. The Microphone Input
the unit and is designed to accept a mono, microphone level signal. Plug the EX-503XD lapel microphone in
to this input. The Aux Input
a stereo, line level signal. This can be used for transmitting audio from the headphone output of a
smartphone or line out of an audio mixer. Additional cables and adapters (not included with this system) may
be required in order to connect line level equipment.
Charging
To charge the transmitter, use the included USB cable and AC adapter. Plug the mini end of the USB cable
into the receiver's Mini USB Charging Port
be plugged into a power socket). Alternatively, the USB-A end of the cable may be plugged into a computer
USB port. Charge time for an empty battery is approximately 3.5 hours. During charging the Power Indicator
will be red; once the battery is full, this light will turn off.
9
will be green. This light will turn red when the remaining battery
on the transmitter has two statuses. When the light is lit solid green it means the
(Fig 2.). Setting the switch in the middle will allow you to use both inputs
is a 3.5mm TRS jack located on the side of the unit and is designed to accept
1
2
7
8
. This switch has 3 settings. Moving the switch
(Fig. 1). Moving the switch towards the words
Fig. 2
is a 3.5mm TRRS jack located at the top of
and then plug the USB-A end into the included AC adapter (to
2
3
4
10
for 1 second. If the unit has sufficient
for 3 seconds until the Power
Fig. 3
5
6