LG LD2050WH Service Manual page 8

11.Base spacer
1) Remove 4 screws.
2) Lift the front side of dishwasher and pull
the base spacer forward.
12. Nozzle-L holder
1) Disconnect the water guide
2) Remove 4screws and lift it up
13. Tub assembly
1) Turn the air guide nut, water softner nut
counter-clockwise.
(Special tool might be needed.)
Be careful the rubber packing of air
guide assembly should not be lost.
2) Remove 3 screws for sump holder .
3) Remove side 6 screws.
4) Remove Earth screw of right side.
5) Lift tub assembly upward.
(Be sure water softner is not blocked.)
Be careful not to be injured or scratch
floor by the sharp edge of tub.
- 14 -
14. Air guide assembly
1) Disconnect the wiring connection.
2) Remove 3 hose assembly.
Be careful the o-ring should not be lost.
15.Water softner
1) Remove the hose assembly.
2) Lift it upward.
Be careful not to wet the floor by the
water left in the water softner.
3) You can disassemble the regeneration.
valve by unscrew the 2 screw.
Be sure not to lost the spring and bobbin.
16. Washing motor, Heater
assembly, Drain motor & sump
1) Remove the screw which tighten washing
motor and base.
2) Lift them upward.
Be careful not to wet the floor by the
water left in the sump.
3) Detach the washing motor and heater
assembly by pulling opposite direction
to sump.
4) Remove the 3 screw for drain motor.
- 15 -