Product Specifications - Dynamix RC 907 EV 35 User Manual

1.2 Product Specifications

V.35 interface:
Physical characteristics: Compliant with V.35 interface standard
Connector type:
Working mode:
Bit rate:
Ethernet interface
Connector type:
Bit rate:
Duplex mode:
Compliance:
Other capabilities:
1. The function of reporting V.35 signal loss alarm to Switches
2. Supports IEEE 802.1d Spanning Tree and IEEE 802.1q VLAN protocols
3. Supports over-sized Ethernet data frame up to 1595 bytes.
4. Supports IEEE 802.3x flow control in full duplex mode
5. Supports back pressure flow control in half duplex mode
6. Built-in 1k MAC address table with address filtering capability to improve the
efficiency of the V.35 link
7. Built-in SDRAM 64M memory to alleviate data congestion
Network management capabilities for RC908-EV35 (NM software is optional)
The network management capabilities include:
1. Set up the phase relationship between transmit/receive data and
transmit/receive clock at V.35 interface;
2. Set up of the buffer capacity;
3. Report operating status of Ethernet port to SNMP server;
4. Set up full/half duplex mode at Ethernet interface;
5. Set up fault-pass-through function;
6. Close the Ethernet interface and disable the modular through NMS
software;
7. Keep history record of all events.
HDB26 female connector (26 pin female port)
DTE
Dependent on DCE equipment, the maximum bit rate up
to 8Mbps
RJ-45 interface, CAT.5/enhanced CAT.5 wires, and the
maximum transmission distance up to 100m
10Mbps
Full/half duplex auto-negotiation
IEEE 802.3