Chapter 1. Introduction; Product Introduction - Dynamix RC 907 EV 35 User Manual

RC907/908-EV35 User Guide

Chapter 1. Introduction

1.1 Product Introduction

RC907/908-EV35 series interface converter, or media converter, is designed to
transmit Ethernet data over V.35 network. Since more and more V.35 network
resources are being deployed, various types of data transmission solutions that
make use of V.35 links will be widely accepted by end-users.
RC907-EV35 series interface converters are standalone interface converters. Every
unit of device has an independence built-in power supply, and can be placed on the
table.
RC908-EV35 series interface converters are slide-in modular interface converters.
They can be installed into RC series 16-slot chassis (19" 3U high chassis),
or 4-slot chassis (19" 1U high chassis), or single slot chassis. When installed
into 16-slot or 4-slot chassis, it can be mixed with other series products (e.g.
copper-to-fiber media converters, single-port optical multiplexers) to enable
uniform network management. RC907-EV35 interface converters can be
deployed at the remote site to work in pairs with RC908-EV35.
RC907/908-EV35 (Rev. B) has interoperability with the previous version (Rev. A).
The differences between the two versions are only at Ethernet interfaces. So it is
not necessary to consider other properties when they interconnect with each other.
The bandwidth setup and clock phase configuration of Rev. B are the same as those
of Rev. A. Please consult our technical support if encountering any problem.