Installing The Globrite Color Light Assembly (After Niche Installation) - Pentair GLOBRITE Installation And User Manual

INSTALLING THE GLOBRITE
To install the GloBrite
1. Route the GloBrite light power cord through the front of the niche, to the
location of the 12 VAC pool transformer or junction box.
2. At the 12 VAC transformer or junction box, cut off any extra cord. Leave
at least six (6) inches (15.2 cm) of cord in the Junction Box or
transformer to facilitate the light installation, niche inspection. Cut off
any extra cord. See Figure 1 on page 7.
3. Strip back the outer cord jacket of the wires to expose the two (2) insulated
conductors. Strip back the two conductors. Be careful not to damage the
copper conductor.
4. Connect the two (2) conductors to the corresponding circuit wires in the
Junction Box (black wire to power, white wire to common). Secure the
Junction Box cover.
5. Install the new GloBrite light assembly: Push the light into the niche
while pulling the power cord from the junction box or transformer, making
sure the locking tabs in the back end of the light are properly aligned with
the niche openings (inside the niche).
Note: When using longer runs of cables or multiple lights per transformer, it is
recommended to use the 13 VAC or 14 VAC tap on the transformer.
Light niche
(gunite niche
shown)
(AFTER NICHE INSTALLATION)
™
color light into the gunite, fiberglass or vinyl niche:
Locking tabs
Light power cord
GloBrite Niche and Light
GLOBRITE™ Color Changing LED Pool/Spa Light Installation and User's Guide
™
COLOR LIGHT ASSEMBLY
Rubber seal
(back of light)
Light assembly
9