Craftsman 580.750290 Operator's Manual page 7

ConnectHosesand Water Supply
.
3.
NOTICE Use ONLYcold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to water
supply.
Run water through garden hose for 30 seconds to flush
the hose of debris. Turn off water.
Confirm that water inlet screen (A) is installed in water
inlet located on left side from front of unit; Do Not
remove except for cleaning.
NOTICE If inlet screen is damaged or missing, DONOT
use electric pressure washer. Call 1-800-222-3136 for
assistance.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
.
5.
• Damageto equipment resulting from failure to follow
this instruction will void warranty.
Attach opposite end of garden hose (B) to the water inlet
coupling (C). Tighten by hand.
Attach high pressure hose (D) to the unit's water outlet
(E) located on right side from front of unit. Tighten by
hand.
ConnectWand and Spray Tip
1. Turn ONwater, point gun in a safe direction, press trigger
lock button (H), then squeezetrigger (J) to purge pump
system and spray gun of air and impurities.
2. Insert and twist plasticwand (K) into spray gun (N). Once
wand slides into gun, applyfurther inwardpressure to
wand and twist 1/4 turn clockwiseuntil securelyin place.
3. Turn OFFwater and releasetrigger. Point gun in a safe
direction and make sure trigger cannot be squeezed.
4. insert the spray tip (N) into plastic wand (P). Once spray
tip slides into gun, apply further inward pressure until it
SNAPSinto place.
NOTICE To remove spray tip, press releasebutton (R) on
wand and pull it away from the wand.
.
Attach opposite end of high pressure hose to the spray
gun. Press red button (F) on spray gun, then insert end
of high pressure hose (6) into gun until it SNAPS into
place. Releasethe red button and make sure connection
is secure.