Whirlpool 4GWTW5500 Use And Care Manual page 9

"8. Select cycle settings
I Hot I Extra Heavy
Warm Heavy l High
Cool l Medium ILow
Cold E]Light E] No Spin
Temp Soil Spin
(_[ Level Speed
Once you select a cycle, the default settings for that cycle
will be lit. Press the cycle settings buttons to change the
Temperature, Soil Level, and Spin Speed, if desired.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
:i
Hot
Some cold water is added to save Whites and pastels
energy. This will be cooler than Durable garments
:: Warm
:: Some cold water will be added,
_:so this will be cooler than what
Bright colors
Moderate to light soils
Cool
Warm water is added to assist Colors that
in soil removal and to help bleed or fade
dissolve detergents. Light soils
Cold
Warm water may be added to Dark colors that
assist in soil removal and to help bleed or fade
dissolve detergents. Light soils
9. Select cycle options
O. Press START/Pause/Unlock
to begin wash cycle
START
Pause/Unlock
Press the START/Pause/Unlock button to start the wash cycle.
Filling is delayed for several minutes while load balance is
sensed.When the cycle has finished, the DONE indicator
will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once
the washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
the lid and press START/Pause/Unlock again to restart
the cycle.
If lid is left open for more than 10 minutes, water will pump out.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling. This
is normal operation.
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Extra Rinse. These can be turned off, if
desired.
NOTE: Not all options are available with all cycles.