dbx AFS2 Owner's Manual page 14

5. WIZARD Button
Press this button to enter the Wizard, which will walk you through the entire AFS2 setup and ring-out procedure.
6. BYPASS Buttons
Pressing these buttons will enable and bypass the AFS filters in each channel. When each button's LED is lit, the
channel is bypassed. Note that when the AFS2 is configured for stereo linked operation, these bypass buttons will also
be linked. Pressing and holding a channel's
Live filters or all filters for the channel.
WARNING!
If AFS is enabled and filters are set, be careful when bypassing the filters as all filters will be
immediately removed from the signal path and sudden feedback could occur. It is recommended that you lower the
mixer outputs feeding the AFS2 before bypassing any AFS filters with the BYPASS buttons.
7. Filter Status LEDs
These LEDs indicate how many filters have been set in each channel – each lit LED indicates a set Fixed or Live filter.
12
button will bring up a menu where you can quickly clear just the
BYPASS