Custom Program; Child Lock; Damp Dry Signal; Wrinkle Care - LG DLE1001W Owner's Manual

HOWTO usz 33
Cycle settings and options (cont.)
DAMP DRY SIGNAL
With this option, the dryer will signal when the load
is approximately 80% dry, This allows you to remove
faster- drying lightweight items or items that you would
like to iron or hang while still slightly damp. Press the
OPTION button to activate or deactivate the DAMP DRY
SIGNAL.
WRINKLE CARE
Selecting this option will tumble the load periodically for
up to 3 hours after the selected cycle, or until the door is
opened. This is helpful in preventing wrinkles when you
are unable to remove items from the dryer immediately,
@ NOTE ---]
u may save only one custorn prograrn at a time. |
ressing and holding the CUSTOM PROGRAM button I
ill overwrite any previously saved custom program. J
J
To Recall a Custom Program:
1. Turn on the dryer.
2. Press the CUSTOM PROGRAM button.
3. Press the START/PAUSE button to start the cycle.
Special functions
The option buttons also activate special functions,
including RACK DRY and CHILD LOCK. Press and hold
the option button marked with the special function
CHILD LOCK
Use this option to prevent unwanted use of the dryer
or to keep cycle settings from being changed while the
dryer is operating. Press and hold the DRY LEVEL button
for 3 seconds to activate or deactivate the CHILD LOCK
function.
The CHILD LOCK icon will be shown in the display, and
all controls are disabled except the POWER button.
_t_o _NOTE "
rice set, CHILD LOCK remains active until it is
anually deactivated, CHILD LOCK must be turned off
run another cycle. To deactivate CHILD LOCK, press
nd hold the DRY LEVEL button for three seconds. 't/
Custom program
If you have a special combination of settings that you
use frequently, you can save these settings as a CUSTOM
PROGRAM.
To Save a Custom Program:
1. Turn on the dryer and press the CYCLES button to
select the desired cycle,
2, Use the cycle setting buttons to adjust the settings for
that cycle.
3, Press the cycle option button(s) for the option you
would like to add.
4, Press and hold the CUSTOM PROGRAM button for 3
seconds,