Brother DCP-J562DW Product Safety Manual page 16

8 Unplug this product from the wall outlet before cleaning the outside of the product. Do not use
liquid or aerosol cleaners. Use a damp cloth for cleaning.
9 Never push objects of any kind into this product through cabinet slots, since they may touch
dangerous voltage points or short out parts resulting in a risk of fire or electric shock. Never
spill liquid of any kind on the product.
10 Do not place anything on top of the power cord including this product. Do not allow the power
cord to be stepped on.
11 Do not place this product on an unstable surface, stand, or table. The product may fall, causing
serious damage to the product.
12 Slots and openings in the cabinet and the back or bottom are provided for ventilation; to ensure
reliable operation of the product and to protect it from overheating, these openings must not
be blocked or covered. The openings should never be blocked by placing the product on a bed,
sofa, rug, or other similar surface. This product should never be placed near or over a radiator
or heater. This product should not be placed in a built-in installation unless proper ventilation
is provided.
13 Do not place anything in front of the product that will block printouts. Do not place anything in
the path of received faxes.
14 Do not touch a document during printing.
15 Not all telephones will respond to incoming ringing when connected to the extension socket.
MFC only
1 The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It
indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.
Above all, it provides no assurance that any item will work correctly in all respects with another
item of Telepermitted equipment of a different make or model, nor does it imply that any
product is compatible with all of Telecom's network services.
2 This equipment does not fully meet Telecom's impedance requirements. Performance
limitations may occur when used in conjunction with some parts of the network. Telecom will
accept no responsibility should difficulties arise in such circumstances.
3 This equipment should not be used under any circumstances which may constitute a nuisance
to other Telecom customers.
4 This equipment shall not be set up to make automatic calls to the Telecom "111" Emergency
Service.
5 This equipment is not capable, under all operating conditions, of correct operation at the higher
speeds for which it is designed. Telecom will accept no responsibility should difficulties arise
in such circumstances.
6 Some parameters required for compliance with Telecom's Telepermit requirements are
dependent on the equipment (PC) associated with this device. The associated equipment shall
be set to operate within the following limits for compliance with Telecom's Specifications:
 There shall be no more than 10 call attempts to the same number within any 30 minute
period for any single manual call initiation.
16
1