Appendix B — Default Settings
Default Configuration
Serial Port Settings
Serial Port Settings
Setting
Baud Rate
Data Bits
Parity
Stop Bits
Hardware
ENQ/ACK
XON/XOFF To
XON/XOFF From
48
Use this appendix to view the default settings on the printer. If you
restore the printer to factory default settings, it will use the values listed
here. The order of the settings reflects the organization of the printer
web page.
This section describes the serial port settings. To view these settings:
•
From the printer web page, click the Configure tab >
Communications > Serial.
Note: These settings are not accessible unless you have the optional
serial port installed and a connection to a PC.
Description
Transmission speed in bits per second (bps) for the
serial port.
Number of bits that define a character or byte.
Specifies how the printer checks the integrity of the
transmitted data.
Number of bits sent at the end of every character to
allow the receiving signal hardware to detect the end
of a character and to resynchronize with the character
stream.
Specifies if hardware flow control (RTS/CTS) is used
to manage the rate of data transmission between the
device and the host.
Specifies if software flow control (ENQ/ACK) is used
to manage the rate of data transmission between the
device and the host.
Specifies if software flow control (XON/XOFF) is used
to manage the rate of data transmission to the host.
Specifies if software flow control (XON/XOFF) is used
to manage the rate of data transmission from the
host.
Default
115200
8
None
1
Disable
Disable
Disable
Disable
PC42t Desktop Printer User Guide