Installing Globrite Light In A Fiberglass Pool - Pentair Globrite Installation And User Manual

6
To 12 VAC
Transformer
Ridgid
1" (3 cm)
Conduit
Installing GloBrite
To install the GloBrite
1. Drill or punch a 2-1/8 inch hole in the desired location for the GloBrite light
niche.
2. Place the sealing gasket on the niche as shown below.
3. Insert the niche through the 2-1/8 inch hole in the pool wall.
4. Install the PVC washer to the back of the niche.
5. Install the plastic nut onto the back of the niche. Hand tighten the nut to
secure the niche in place.
6. Glue the 1" conduit into back of niche.
1" Conduit
GloBrite Light Niche (Fiberglass pool) Installation Diagram
GLOBRITE™ White LED Pool /Spa Light Installation and User's Guide
48" min. (1.22 m)
4" (10.2 cm)
min.
Niche Sleeve: 2" PVC Pipe
( 15" min.) ( 35.1 cm )
For Gunite Niche Only
Figure 1: Gunite Light Installation Diagram
™
Light Niche in a Fiberglass Pool
™
light niche in a fiberglass pool:
Niche
8" min. (20.3 cm)
Niche Sleeve
(cut flush to wall
before plastering)
Plaster Finish
Pool wall
Nut
PVC washer
4" min. (10.2 cm)
to top of lens
Color Ring and Gunite Cover
Sealing gasket