Safety Instructions WARNING: Failure to follow these safety instructions could result in fire, electrical shock, release of harmful vapors, personal injury and other damages. Only manufacturer authorized personnel can open/repair the PowerPad. The warranty will be voided if these instructions are not followed. •...
Getting Started Unpack and make sure there are no damages to the PowerPad. The PowerPad will not be fully charged when it is shipped. Read all the instructions before using it. PowerPad features DC output port(s), an AC input port, a DC input port, an ON/OFF switch, and a battery status LED. The serial number can be found on the label on top of the PowerPad.
Page 5
DC Output Port ON/OFF Switch DC Output Port Battery Status LED DC Input Port AC Input Port...
What to Prepare AC Input Connector 1: Line : Ground 4: Neutral Harting Part Description Part Number Quantity Required Female Insert Small - 14AWG 09120053101 Female Contact - 14 AWG 09330006202 Cable Housing Head - Small 19200030410 Wire - 14AWG Accordingly to Length DC Input Connector 1: (+) Positive...
Battery Status LED PowerPad features LED lights that show the status of the PowerPad. The 5 battery level indicator LEDs show how much capacity is remaining. The charging indicator LED will turn green while the PowerPad is charging. Battery Level Indicator LEDs Charging Indicator LED Battery Status Charging...
Charging PowerPad PowerPad can be charged either from AC or DC power source according to the specifications below. PowerPad AC Input Specifications Frequency 50/60 Hz, single phase AC Input Voltage 110 - 230V PowerPad DC Input Specifications DC Input Voltage 12 - 18 V WARNING: Do not charge the PowerPad from the AC and the DC input simultaneously.
Using PowerPad PowerPad has DC output port(s) and is compatible with the DC device(s) with the specifications below. PowerPad DC Output Specifications DC Output Voltage 12 -16 V Maximum Power 300 Watts (Total of both DC devices) 1: Plug-in the DC connector to the DC output port Open the lid of the DC output port and make sure there are no foreign objects inside the ports.
Linking PowerPads PowerPads can be linked to each other so that if the PowerPad connected to the electronic device has a low battery level the 2nd PowerPad can provide power to the electronic device and it does not have to shut down. •...
Page 11
1: Connect the DC output port of the PowerPad that is charged to the DC output connector. Open the lid of the DC output port and make sure there are no foreign objects inside the ports. The numbers on the DC output connectors must be connected to the same numbers on the DC output ports.
Operating Temperature The operating temperature of the PowerPad is between 5°C (41°F) to 45°C (113°F). However, to extend the life of the battery, it is recommended to maintain the temperature range between 10°C (50°F) to 35°C (95°F). WARNING: The PowerPad will stop operating when it’s exposed to temperature below 5°C (41°F) and above 45°C (113°F).
Transportation Transporting rechargeable lithium ion batteries are in most cases, limited or prohibited without obtaining permits and following regulations. Check all applicable local, national, and international regulations before transporting the lithium ion battery. As of January 2013, lithium ion batteries are required to be compliant with IATA (International Air Transport) regulations for air shipment.
Trouble Shooting The following table provides solutions for problems that may arise. If you do not find a solution for you specific problem, or the problem continues after trouble shooting please contact Electrovaya Customer Service at 1-905-855-3074 or at customerservice@electrovaya.com...