Hotpoint MPX103 Instructions For Use Manual page 5

Getting started
and using your oven
Setting/changing the time
After connecting your appliance or after an extended power cut, 00:00 flashes in the display.
To set the time, example: 06:30
Press the + or - buttons to set the desired time (06).
Confirm by pressing CLOCK.
Then set the minutes (30) by pressing + or -.
Confirm by pressing START-STOP.
A beep sounds to confirm that the time has been set.
To change the time
Press the CLOCK button. The time display
flashes.
Set the new time, using the + or - buttons
Confirm by pressing the CLOCK button.
Then set the minutes (30) by pressing + or -.
Confirm by pressing START-STOP.
There is a beep to confirm that
the new time has been set.
Comments: If you do not press the clock button, the time displayed is automatically saved after 10 seconds.
Programming
Your appliance is now connected and the correct time is set.
Use the handle to open the door. Put the food inside and close the door.
If the door is not closed properly, the appliance will not work.
If the door is opened during a programme, the programme is not cancelled, just interrupted. To restart the oven, close the
door and press the button again.
If, after programming, there is no action for thirty minutes, the display shows the time with reduced brightness.
To enter a second programme at the end of the first one, press
Press the button to cancel a programme in progress (OFF is shown in the display).
Three beeps sound to signal the end of each programme.
If the door is left open, the light turns off after 3 minutes.
When your appliance goes into standby after thirty minutes, you can re-activate it by pressing the
shown in the display).
To remove moisture, your appliance has a delayed fan function. Depending on the cooking mode chosen (solo/grill/com-
bined), the oven fan may continue to run at the end of the programme. It will stop automatically.
, open the door and then close it again.
Display
Display
button (ON is then
5
GB