Hotpoint MPX103 Instructions For Use Manual page 3

Installing your appliance
220-240 V~ single-phase line
16A fuse or differential
Electrical outlet
2 prong receptacle +earth
to IEC 60083 standard
CONNECTING TO THE POWER SUPPLY
The appliance must be recess-fitted correctly to ensure electrical
safety. During fitting and maintenance operations, the appliance
must be unplugged from the electrical system; fuses must be
switched off or removed.
The electrical connections are made before the appliance is
installed in its housing.
Ensure that:
- the electrical installation has sufficient power,
- the electrical wires are in good condition,
- the diameter of the conductors complies with the requirements
of the installation.
Your oven must be connected via a (standard) 3 x 1.5 mm
cable (Ph + N + earth) which must be connected to a 220-240V ~
single-phase supply via a single phase + neutral + earth standard
power socket to IEC 60083 or via an all-pole isolator complying
with the requirements of the installation.
Warning
The safety wire (green-yellow) is connected to the appli-
ance's terminal and must be connected to the electrical
installation's earth terminal.
It must be possible to disconnect the appliance from the mains
after installation.
Disconnection may be achieved by providing an accessible plug
or by incorporating a switch in the fixed supply cabling, comply-
ing with installation rules.
The installation's fuse must be rated at 16A.
If the power cable is damaged, it must be replaced by the manu-
facturer, its after-sales service department or similar qualified
personnel, to prevent any danger.
circuit breaker
Power
supply cable
length 1.50 m
approx.
2
power
Single phase 20A Meter
220-240V ~ 50 Hz
Warning
We cannot be held responsible for any accident or inci-
dent resulting from non-existent, defective or incorrect earth-
ing.
If the electrical installation in your residence requires any
changes for connecting your appliance, call a qualified electri-
cian.
If the oven malfunctions in any way, unplug the appliance or
remove the fuse for the circuit to which the oven is connected.
GB
3