AIRTRONICS M11X FHSS-3 Operating Manual page 10

DRIVING POSITION ADJUSTMENTS
DIGITAL TRIM RING POSITION
The position of the digital trim ring can be repositioned to
better suit your taste. Five different positions are available.
1) Remove the M4 socket-head cap screws on each side
of the transmitter using a 3mm hex wrench.
Trm 1 is factory set at the top center position.
2) Detach the grip downward from the upper transmitter
unit. Be careful to avoid damaging the wires that are
connected on both units.
3) Remove the three M2.6 socket-head cap screws from
the back of the digital trim ring (behind the steering
wheel), using a 2mm hex wrench.
4) Rotate the digital trim ring to the desired position. The
digital trim ring can be positioned in one of five different
positions. Set the digital trim ring at the desired position,
then retighten the three M2.6 socket-head cap screws.
5) After setting the digital trim ring position, align the upper
transmitter unit and reinstall it using the two M4 socket-
head cap screws.
STEERING WHEEL POSITION
The steering wheel position can be changed from the right
side to the left side to accommodate left-handed users.
1) Remove the M4 socket-head cap screws on each side
of the transmitter using a 3mm hex wrench.
2) Detach the grip downward from the upper transmitter
unit. Be careful to avoid damaging the wires that are
connected on both units.
3) Set the Left/Right selector switch to 'L' located above
the Trm 4 and Trm 5 switches.
4) Rotate the grip by 180 degrees, then align the upper
transmitter unit and reinstall it using the two M4 socket-
head cap screws.
3
Page 10
1
1
4
4
1
3
3
3
4
1