Remote Control - Insignia NS-28D220NA16 User Manual

NS-28D220NA16 28" 720p 60Hz, LED TV
Problem Solution
The picture
• A few bright or dark spots on an LCD
has a few
screen is normal. It does not affect
bright or dark
the operation of your TV.
spots.
Good picture,
• Increase the volume.
but no sound.
• Make sure that the sound is not
muted.
• Make sure that you do not have
headphones connected. When
headphones are connected, no
sound comes from the TV speakers.
• Press AUDIO to change to a
different audio mode.
• If you are using a home theater
system, sound bar, or external
speaker system, make sure it is
turned on and is not muted.
• If you are using a home theater
system, sound bar, or external
speaker system, make sure that you
have selected the correct output
mode.
• If you are using a home theater
system, sound bar, or external
speaker system and have connected
it with a digital cable, go to the
Audio menu, highlight Digital
Audio Format/Audio Delay, then
press ENTER. Set the Audio Format
option to PCM. See the Digital
Audio Format/Audio Delay option
in Adjusting sound settings
47.
• Make sure that the audio cables are
connected correctly and securely to
your TV.
• Make sure that the antenna or cable
TV is connected correctly and
securely. See
satellite box
Connecting an antenna or cable TV
(no box)
• If you are using an antenna, the
digital channel signal may be low. To
check the digital channel signal
strength, see
signal strength
• The audio cables you are using may
be bad. Try a new set.
Poor picture.
• Make sure that the room is not too
bright. Light reflecting off the
screen can make the picture difficult
to see.
• If an S-VHS camera or a camcorder is
connected while another connected
device is turned on, the picture may
be poor. Turn off one or more
devices.
Good sound,
• Adjust the contrast, color, and
but poor
brightness settings. See
color.
the TV picture
on page
Connecting a cable or
on page 14 or
on page 18.
Checking the digital
on page 52.
Adjusting
on page 45.
www.insigniaproducts.com
Problem Solution
Audio noise.
• Other devices (for example, a
surround sound receiver, external
speakers, fans, or hair dryers) may
be interfering with your TV. Try
turning off one device at a time to
determine which device is causing
interference. After you have
determined which device is causing
interference, move it further from
the TV to eliminate the interference.
No output
• Adjust the audio balance. See
from one of
Adjusting sound settings
the speakers.
page 47.
• Make sure that the audio cables are
connected correctly and securely to
your TV.
After images
• Do not display a still image, such as
appear.
a logo, game, or computer image,
for an extended period of time. This
can cause a permanent after-image
to be burned into the screen. This
type of damage is not covered by
your warranty.

Remote control

Problem Solution
Remote
• Make sure that the power adapter is
control does
plugged into a working outlet.
not work.
• Make sure that there are no
obstructions between the remote
control and the remote control
sensor on the front of the TV.
• Point the remote control directly at
the remote control sensor on your
TV. For the location of the remote
control sensor, see
remote control
• The supplied batteries are wrapped
tightly in clear plastic. Make sure
that you have removed this plastic
from the batteries.
• Make sure that the batteries are
installed correctly. See
remote control batteries
page 32.
• Replace dead batteries with new
batteries. See
control batteries
on
Aiming the
on page 32.
Installing
on
Installing remote
on page 32.
67