Table of Contents
Advertisement
Vax V-045N User Guide.qxd:V-112P User Guide
www.vax.co.uk
The HEPA filter may also be washed by running it under the
tap, allowing the water to run on the dirty side (Fig.6/7).
Fig.6/7
Vax recommends washing the HEPA filter once a month, or
when suction appears reduced.
Always allow the filter to air dry for 24 hours before
replacing into the cleaner.
NOTE: The white material in the HEPA filter will discolour
over time; this is NORMAL and will NOT affect the
performance of the filter.
WARNING: Always empty the dirt container and
!
clean the HEPA filter and debris screen before each
use and after prolonged use. Never overfill the dirt
container.
Remove dirt and clean the HEPA filter and debris screen
each time the dirt container is emptied or after prolonged
use. Failure to do so may cause motor damage.
Cleaning the HEPA Filter Frame
Before replacing the HEPA filter in the HEPA filter frame,
rinse the frame in lukewarm (max 40ºC) water by running it
under the tap. This will remove any dirt on the frame
(Fig.6/8). Do NOT place in dishwasher.
Fig.6/8
Ensure the filter frame is completely dry before replacing
into the dirt container. Always air dry for 24 hours.
Cleaning the Pre-Motor Filter
Located beneath the dirt container is a pre-motor filter,
which fits into the air inlet pipe. Lift out to remove (Fig.6/9).
Fig.6/9
8
dirt container & filter
22/5/08
12:21
Page 8
Cleaning the Exhaust Filter
To remove the exhaust filter, twist the pre-motor filter cover,
then remove the exhaust filter (Fig.6/10).
Fig.6/10
To clean the pre-motor filter and exhaust filter, rinse in
lukewarm (max 40ºc) water and let air dry completely for 24
hours. Do not use a washing machine to rinse the filters. Do
not use a hair dryer to dry them. Air dry only. Never operate
the vacuum cleaner without all filters in place.
NOTE: Vax recommend washing the pre-motor filter when
washing the HEPA filter (Fig.6/11).
Fig.6/11
Cleaning the Dirt Container
WARNING: To reduce the risk of electric shock, the
!
power cord must be disconnected before removing the
dirt container or HEPA filter, or before changing the
filters or performing maintenance/ troubleshooting checks.
• The dirt container can be washed in lukewarm (max 40ºc)
water.
• Do not use strong detergents.
• Ensure the dirt container is fully dry before re-attaching to
the vacuum cleaner (Fig.6/12). Do not wash in dishwasher.
Fig.6/12
Advertisement
Table of Contents
