Vax DynamoPower U85-DP-Be Getting Started Manual page 12

Let's talk technical
Removing blockages from the TurboTool (some models only)
Remove the rubber ring.
Changing the belt
Lift the brushbar from the
machine to remove the
belt. Remove and dispose
of the old belt. Remove
any threads or hair caught
around the brushbar
Push both buttons to open the TurboTool.
Using a pair of scissors, cut
any hair or debris free from
around the brushes.
Switch off your vacuum
cleaner at the main socket
and unplug. Unclip the 2
small wheels from the base
of the vacuum to enable you
to remove the screws from
behind. Note: The screw for
the height adjuster dial is
located here.
Clean any debris from the
spindle and place the new
belt onto the brushbar and
hook onto the spindle.
Remove the 9 screws
from the base of the
floorhead cover.
Once the belt has been
replaced attach the
brushbar back onto the
vacuum.
If the hose or telescopic
tube is blocked, switch off
the vacuum cleaner and
remove the blockage(s)
before re-starting the
vacuum cleaner.
CAUTION
Remove the floorhead cover.
Replace the floorhead
cover, 2 small wheels and
height adjuster dial by
screwing back into place.