Installation; Water Connections - Beko WKD 24500 TS User Manual

Installation

6
If your system is not ready, let a certified plumber make it
ready.
1. Removing the transportation safety bolts
Before the washing machine is operated, the transit bars
must be removed! In order to do this:
1. Loosen "C" bolts by rotating them counter clockwise
with a suitable spanner
2. Remove transportation safety bolts by turning.
3. Place "P" plastic covers onto the openings of transpor-
tation locks by rotating in direction of arrow and pushing.
Attention please! Keep the transit bars for using when
machine is to be transported again. Always transport your
machine with transportation locks.
2. Leveling the feet
In order to operate your machine without noise and
vibration it must be properly on balance. Four feet of your
machine can be adjusted. First loosen the plastic counter
bolt. Tighten the counter bolt after adjusting the feet for
leveling your machine.

3. Water Connections

a) Water Inlet Hose
Your machine is connected to water supply by special
hoses supplied by the machine. Red hose or hose
written red on it is hot water inlet, blue hose or hose
written blue on it is cold water inlet.
There are plastic seals (4 for double water inlet mod-
els, 2 for single water inlet models) on hose or plastic
bag for eliminating any leakage in connections points.
These seals must be used on each side of the con-
20