Subaru 2004 Impreza Service Manual page 36

EXTERIOR/INTERIOR TRIM
CAUTION:
Do not heat the double-sided tape until the sur-
face becomes white and excessively dried.
5) Remove the double-sided tape using a plastic
spatula.
6) After completely removing the double-sided
tape, detach the masking tape and clean the sur-
face using a cotton cloth waste damped with white
gasoline.
B: INSTALLATION
1. LARGE-SIZED ROOF SPOILER
Install in the reverse order of removal.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.46 ft-lb)
2. SMALL-SIZED ROOF SPOILER
1) Apply the primer to spoiler surface where the
double-sided tape is adhered, and then adhere the
double-sided tape as shown in the figure.
: (A)
(F) Front side
(A) Double-sided tape; thickness:
0.8 mm (0.031 in), width: 5 mm (0.197 in)
Primer:
3M K-500 or equivalent
Double-sided tape:
3M 5531-5 or equivalent
2) Heat the adhering part using a heat lamp.
Body side: 40 — 60°C (104 — 140°F)
Spoiler side: 20 — 30°C (68 — 86°F)
3) Detach the double-sided tape backing sheet,
align to clip position, and then adhere to body using
care to avoid air entering.
Roof Spoiler
(F)
EI-00481
CAUTION:
To keep the adhesion, do not wash the vehicle
within 24 hours.
(A)
(A) Cap oblong hole
(B) Washer nozzle
(C) Cap round hole
EI-34
(C)
(B)
EI-00482