Voltikus Rear Panel Explained; Replacing A Voltikus Fuse - Antelope Zodiac Platinum DSD256 Owner's Manual

Hide thumbs Also See for Zodiac Platinum DSD256:

Table of Contents

14. Voltikus Rear Panel Explained

31. Fuse compartment

Takes two fuses: 0.8A, 250 VAC, 5 mm x 20 mm, Type F.

32. Power switch

Toggles power on/off.

33. IEC AC Input C14 Male Connector

For use with supplied AC Power cable.

34. Ground/Lift switch

Toggles grounded or lifted state.

35. 18 VDC Output

For use with supplied Antelope DC Power cable only.

If the power light is not illuminated and the Voltikus is plugged into a working AC power outlet with

the power switch in the on position, the fuse may need to be replaced.

● Disconnect the power cord from the electrical outlet.

● Insert a flat blade screwdriver into the notch at the bottom edge of the fuse holder (31) to

release it. (See image below).

● Remove the fuses from the fuse holder. Replace them with 0.5A 250V Time Lag (Slo-Blo)

Littelfuse Inc. P/N: 0218.500MXP

Table of Contents