Reset To Factory Default Settings; Further Information - Axis M1103 Installation Manual

Page 12

Reset to Factory Default Settings

Reset to factory default should be used with caution. A reset to factory default will reset all
settings, including the IP address, to the factory default values.
The installation and management software tools are available on the CD supplied with the
product and from the support pages on www.axis.com/techsup
To reset all parameters and the IP address to Factory Default settings:
1. Disconnect the power from the product.
2. Press and hold the Control button and reconnect power.
3. Keep the Control button pressed for about 15-30 seconds until the Status LED indicator flashes
amber.
4. Release the Control button.
5. When the Status indicator displays green (which can take up to 1 minute) the process is
complete and the product has been reset to factory default settings.
6. Using the installation and management software tools, assign an IP address, set the password,
and access the video stream.

Further information

The user's manual is available from the Axis web site at www.axis.com or from the Axis Network
Video Product CD supplied with this product.
Visit www.axis.com/techsup to check if there is updated firmware available for the AXIS M11
Series. To see the currently installed firmware version, see Setup > About in the camera's web
pages.
AXIS M11 Series Installation Guide