Bryant 538F Owner's Manual page 33

OUTDOOR UNIT INSTALLATION FOR SINGLE ZONE APLICATIONS
(REFER TO THE 538K OWNER'S MANUAL FOR MULTIZONE)
2. Fix the power connection wire and signal control wire with wire clip (only for
cooling and heating unit).
tightening
Step six: neaten the pipes
1. The pipes should be placed along the wall,
bent reasonably and hidden possibly. Min.
semidiameter of bending the pipe is 10cm.
2. If the outdoor unit is higher than the wall
hole, you must set a U-shaped curve in the
pipe before pipe goes into the room, in
order to prevent rain from getting into the
room.
Note:
pipe hole of indoor unit.
in water in order to drain smoothly.
The water outlet
can't be placed
in water
the drain hose
can't raise
upwards.
The drain hose can't be fluctuant
-33-
U-shaped curve
drain hose
The drain hose
can't be fluctuant
wall
The water
outlet can't be
fluctuant